IO Test Project Demonstration

In this video I will show you the I/O test project by Noritake itron. This project will allow you to test your own projects by connecting the appropriate IO ports. The project loads up and shows an introduction page which shows the pinout of the 31 IO ports on the TFT. You can the open the terminal or setup page. In the setup page you can change the parameters type to output or input, edge to falling or rising, trigger to ON or OFF, Keyboard to ON or OFF, Pull-Up Resistors to ON or OFF - we recommend these are turned on when using as an input, Status as active or inactive. The setup page also has as a show hex button which will show the current saved keyio setup allowing you to check this matches your code. Be sure to save the changes before exiting. In the IO terminal inputs are indicated by the red buttons and outputs by blue, and the inactive ports are greyed out. Inputs will go red when high and depending on the trigger status the value may count up. You can make the outputs low to high or high to low depending on the low/high button. When you press an output it will go gold and the like the inputs depending on its status the counter may count up. This project as well as many others can be found on the itrontft website under projects.